Skip to content
Blog

Design Build Electrical and HVAC in South Florida

Design Build Electrical and HVAC in South Florida: How It Works

Most building owners have lived through it at least once. The engineer draws the job, the contractor bids it, the bids come in high, the drawings get changed, and by the time anyone is turning a wrench the schedule is already behind. Then the change orders start. Design build is a different way to run the job, and for electrical and HVAC work on large buildings it often makes a lot of sense.

We handle design build electrical, HVAC and fire alarm construction across Broward, Palm Beach and Miami Dade. Here is how it works, where it fits best and what owners should ask before they go that route.

In a design build job, one team is responsible for both the design and the installation. Instead of hiring an engineer to draw everything and then putting the drawings out to bid, the owner brings in a contractor who works with the design professionals from the start. The people who will install the gear help decide what gear gets installed and how.

That does not mean skipping engineering or permits. Drawings still get prepared and sealed where the building department requires it, and the work still gets permitted and inspected. The difference is that the design is shaped by people who know what it takes to build it, what equipment is actually available and what it costs today.

Electrical and mechanical systems are where a lot of the money and the risk sit in a commercial job. A few reasons design build fits them:

Switchgear, generators, chillers and air handlers can take a long time to arrive. When the builder is part of the design, equipment can be selected and ordered early, around what is really available.

Electrical and HVAC have to line up. Chillers, cooling towers, air handlers, RTUs and VRF systems all need the right power, the right controls and the right path into the building. One team means fewer gaps between trades.

A contractor who walks the building before the design is finished catches the problems that do not show up on old drawings, like a full electrical room or a roof that needs support for new equipment.

The owner is not stuck in the middle between the engineer and the contractor when something does not fit.

Replacing a chiller plant, a cooling tower, rooftop units or a large switchgear lineup, where the new equipment has to fit the existing building.

Upgrading the electrical and HVAC systems in an older building, often while parts of it stay open.

Sizing, placing and tying in a new generator and transfer switches.

Hospitals, assisted living facilities, hotels and manufacturing plants that cannot shut down while the work gets done.

It is less of a fit when the owner already has a complete, finished set of drawings and just wants the lowest price on that exact scope. In that case a straight bid can make sense.

Every project is different, but the steps tend to look like this:

Need this looked at on your building?

Call the Sunrise office or send the address. We will tell you what we see.