Skip to content
Blog

Hospital Air Handler Replacement in South Florida

Hospital Air Handler Replacement in South Florida: Planning Without Shutting Down

In a hospital, the air handlers do a lot more than keep people comfortable. They hold pressure in operating rooms and isolation rooms, they control humidity in sterile storage, and they move the air that infection control depends on. When one of them is near the end of its life, replacing it is a planning job first and a mechanical job second.

We work on HVAC and electrical systems in healthcare buildings across Broward, Palm Beach and Miami Dade. Here is how we think about air handler replacement when the building can never really shut down.

Air handlers in South Florida hospitals run hard every hour of the year. These are the things that usually tell us a unit is done:

The casing is rusted through or the drain pan is leaking, which puts water and growth right in the airstream.

The coils are corroded and cleaning no longer brings back capacity.

The fan, bearings or motor keep failing, or the fan wall was patched together over the years.

The unit cannot hold the humidity the spaces it serves need.

Humidity is the big one here. A unit that cannot dry the air leaves sterile supply rooms and procedure rooms out of range, and that turns into a problem with the people who inspect the hospital.

A hospital air handler is tied to rules that most buildings never deal with. Healthcare ventilation follows ASHRAE 170 and the FGI Guidelines, which set air change rates, filtration, pressure relationships and humidity ranges for different rooms. Operating rooms stay positive to the corridor. Airborne isolation rooms stay negative. Those relationships have to hold during the work, not just after it.

In Florida, hospital construction is reviewed by the Agency for Health Care Administration in addition to the local building department. That means drawings, an approved plan and inspections that are tougher than a typical commercial job. Build that time into the schedule from the start.

Before anything else, map every room on that air handler and what it needs. A unit that serves offices and one that serves a surgical suite get very different plans.

Critical spaces cannot sit without conditioned air. That can mean a temporary air handler, cross connecting to another unit, or scheduling the work around when certain rooms are closed. Sometimes it means doing the work in stages.

Any work above ceilings or in mechanical rooms near patient areas needs an infection control risk assessment with the hospital's team. That sets the barriers, negative air machines and cleaning the crew has to follow.

Many hospital air handlers sit in tight mechanical rooms that were built around the old unit. New units often come in sections, or get built in place, so they fit through existing doors and chases. We check the path before ordering anything.

New fans, motors and drives change the electrical load. Many hospital air handlers also run on the emergency power system, so the new unit has to be fed from the right branch and the generator has to be able to carry it. Because we hold both the HVAC license (CAC1825204) and the electrical license (EC13006438), we handle the feeders, disconnects, drives and controls wiring in the same plan as the mechanical work. That keeps the electrical from becoming a surprise at startup.

Need this looked at on your building?

Call the Sunrise office or send the address. We will tell you what we see.