Skip to content
Blog

Infrared Thermal Imaging for Plants and Large Facilities

Infrared Thermal Imaging for Electrical Systems in Manufacturing Plants and Large Facilities

Most electrical failures we get called for did not happen all at once. A lug loosened. A breaker started running hot. A bus joint corroded. For months it was getting warmer, and nobody could see it. An infrared camera sees it.

If you run a manufacturing plant, a distribution center or any large facility in South Florida, an infrared scan of your electrical gear is one of the cheapest pieces of insurance you can buy. Here is what it finds, what the standards now say, and how to get a scan that is worth the money.

Electrical problems make heat before they make smoke. An infrared camera shows temperature differences across equipment while it runs under load. The usual findings:

Loose or poorly torqued connections at lugs, bus joints and breaker terminals

Unbalanced phases, where one phase runs much hotter than the other two

Hot spots in transformers, motor control centers and disconnects

The scan does not fix anything. It tells you where to look, how urgent it is, and what can wait for a planned shutdown. That last part is the value. Fixing a hot connection on a Saturday is a maintenance job. Fixing it after it fails on a Tuesday is a lost production day.

For decades, NFPA 70B was a recommended practice. With the 2023 edition it became a standard, written in mandatory language that insurers, owners and authorities can enforce. The 2023 edition set infrared thermography of electrical equipment at least every 12 months as a baseline, and every 6 months for equipment in poor condition.

The current edition is 2026. One change worth knowing: it allows permanently installed, continuously monitoring temperature sensors to satisfy the thermography requirements. For gear that is hard or risky to open, that can be a better answer than an annual scan.

Insurers have noticed. Some now recommend annual infrared surveys at industrial sites as part of their risk programs. If your carrier has asked for a scan report, this is why.

Many scans require opening covers on energized equipment. That is energized work, and NFPA 70E applies: a qualified person, a risk assessment, arc flash labeling you can trust, and the right PPE. Anybody who shows up and starts pulling panel covers without talking about that is the wrong crew.

Infrared windows installed in switchgear covers let a thermographer see inside without opening anything. On large switchgear and MCCs, we think they are worth installing, especially if you are scanning every year.

A hot connection at 20 percent load may look fine. Schedule the scan during normal production, not on a slow shift.

Each finding should have an image, a normal photo, the location, the load at the time, the temperature difference, and a priority. A stack of pretty pictures with no priorities is not a report.

The scan is only half the job. After repairs, a quick follow up image confirms the problem is gone.

Need this looked at on your building?

Call the Sunrise office or send the address. We will tell you what we see.