Skip to content
Blog

Manufacturing Cooling Tower Replacement South Florida

Cooling Tower Replacement for Manufacturing Plants in South Florida

In a manufacturing plant, the cooling tower is one of those pieces of equipment nobody thinks about until it stops working. Then the process water runs hot, the chillers trip, and the line slows down or stops. In South Florida, where the heat and humidity never really let up, a cooling tower works hard almost every day of the year.

We replace and retrofit cooling towers for large facilities across Broward, Palm Beach and Miami Dade. Here is what plant managers and owners should know when a tower is getting close to the end.

Towers do not usually fail all at once. They wear out a piece at a time. Watch for these:

Once the structure is corroded through, patching only buys time.

Bad fill means poor heat transfer and higher leaving water temperatures.

Noise, vibration and repeat repairs on the drive are a warning.

If the tower cannot hold its temperature on hot afternoons, the chillers and the process pay for it.

When every year brings a bigger repair, it is time to price a replacement.

Not every tired tower needs to be replaced. If the structure and basin are sound, a rebuild with new fill, drift eliminators, nozzles and drive parts can bring it back. If the casing, basin or frame is failing, replacement is usually the better money.

We look at the whole picture before we recommend anything: the condition of the tower, its age, how hard the plant runs it, and whether it is still the right size for the load today. Many plants have added equipment over the years, and a tower that was sized years ago may not keep up anymore.

The biggest concern in a plant is downtime. A good cooling tower replacement is planned around the production schedule, not the other way around. That usually means:

Scheduling the change over for a planned shutdown, a slower season or a weekend.

Where the plant cannot go without cooling, a rental tower or temporary cooling can carry the load while the new tower goes in.

Building the new supports, piping connections and electrical before the old tower comes out, so the actual swap is as short as possible.

Many towers sit on roofs or in tight yards, so the lift gets planned early.

Need this looked at on your building?

Call the Sunrise office or send the address. We will tell you what we see.